PropSmith Inboard Prop Puller 5.00"

PropSmith Inboard Prop Puller 5.00"

PropSmith Prop Puller for 5.00" SAE Shafts.

GetaGrop has the only tool that is both a prop “pusher” as well as a prop puller, with the substantial force that is developed pressing the hub directly in line with the shaft, either onto or off the taper. Used and recommended by many quality boat builders, including Viking, Hatteras, Cabo, Delta, Tiara, Ocean, Albemarle, Post, Rampage, SeaRay, Sculley, Burger, Spencer, Lazzara.

  • For Installation, the Propsmith seats the prop very forcefully up onto the taper
  • Without hammers, wrench extensions, blocking of blades, risk of bent tips or scarred shafts
  • Eliminates risk of prop loosening on taper, leading to vibration, keyway cracks, or shaft failure
  • For Removal, the Propsmith exerts the same high force, (up to 40 tons) directly down the taper to pull the prop
  • Not affected by diameter, number or overlap of blades, or space between strut and blades
  • No contact with blades, so no risk of damage from chains, hooks, or slipping clamps
  • Sizes available for all standard propeller shaft diameters from 1 ¾” to 6”. Units for metric or left handed threaded shafts available on special order
  • All Propsmith Pullers come in durable plastic cases for space saving on-board stowage in engine room or tool locker




Write a review

Note: HTML is not translated!
    Bad           Good

Captcha
  • Product Code: Propellersmith 5.00
  • Availability: 1
  • $1,722.00