Bob's Manual Jack Plate

Bob's Manual Jack Plate
Bob's 4 In 1 Convertible Manual Jacking Plate available in four different configurations.

100-205000 Manual Jack Plate: (5" Setback) with 6 degree Wedge, Rated up to 200hp.

100-205100HD Manual Jack Plate: (5" Setback) Heavy Duty with 6 degree Wedge, Rated up to 300 HP or 625lb motors.

100-208000 Manual Jack Plate: (8" Setback) Rated up to 200hp.

100-208100HD Manual Jack Plate: (8" Setback) Heavy Duty 8" Offset, Rated up to 300hp or 625lb motors.

Jacking bolts- allow motor to be moved to any height. No need to take boat out of the water.
Offset- positions motor 5 1/2 inches behind transom. This allows prop to run in cleaner water, away from the turbulence and bubbles created by the hull. This helps stop slippage of prop, and helps stop torque in steering wheel at high speeds.
Trim-In- this allows motor to be trimmed in or down 6 degrees more than if mounted flat on transom. Helps stop low speed porpoising. Balance load better.
Light-weight- approximately 20lbs., constructed of aircraft grade aluminum and stainless steel.
Anodized black finish to prevent corrosion. Anodize also lets paint stick to aluminum if painting is preferred.
Narrow designed- only inches wide, make this plate possible to fit the narrowest of transoms.
Fits V-6- pre-drilled to fit all late model V-6's. Can be modified to fit any size outboard.

Write a review

Note: HTML is not translated!
    Bad           Good

  • Product Code: MANUAL2PC
  • Availability: In Stock
  • $269.95

Available Options