Getaprop > PWC Impellers > Honda Impellers

Solas Impeller Honda HA-CD

Concord Series HA-CD Fits 2002-2004 Honda 1235cc PWC... (12/18) 2004 R-12 2002-04 F-12 Engine CC: 1235 Wrench Impeller: 08-WR001 Seal: 08-SLA010 Speed Begins With A Solas Impeller - Designed for speed, handling, and durability, all Solas impellers are made of an ultra high strength stainless steel with one-piece molding to achieve a consistent pitch. Recognized worldwide, Solas offers you a choice of innovative designs. The new Concord impellers feature a radial blade design. Built to enhance all-around performance, the Concord will maintain top-end speeds, while increasing low-end power for towing or carrying more passengers. Also improves blast-off power and allows better hook-up in choppy water.

Solas Impeller Honda HA-CD

Concord Series HA-CD Fits 2002-2007 Honda 1235cc PWC... (17/29) 2004-07 R-12X 2002-07 F-12X 2002-2007 F-12X GPScape Engine CC: 1235 Wrench Impeller: 08-WR001 Seal: 08-SLA010 Speed Begins With A Solas Impeller - Designed for speed, handling, and durability, all Solas impellers are made of an ultra high strength stainless steel with one-piece molding to achieve a consistent pitch. Recognized worldwide, Solas offers you a choice of innovative designs. The new Concord impellers feature a radial blade design. Built to enhance all-around performance, the Concord will maintain top-end speeds, while increasing low-end power for towing or carrying more passengers. Also improves blast-off power and allows better hook-up in choppy water.

1. Remove and separate the whole jet pump from the PWC. 2. Remove the trail cone (or cap) from the stator. 3. Hold the rear end of the shaft with a bench vice Remove the Impeller with an Impeller wrench (optional part) Turning counter clockwise will loosen the Impeller 4. Visually inspect thread on shaft & Impeller for debris or damage. Apply grease or anti-seize on the thread before installation. 5. Screw in the Impeller by hand; please be careful of the sharp edges of the Impeller. Tighten with the Impeller wrench. If the Impeller feels too tight or not threaded properly, unscrew the Impeller, clean and check the threads. 6. Assemble the pump and refill O/E pump oil or grease to spec. This installation guide is suggested for reference only. (Please refer to your origional service manual or contact your PWC dealer for detail.)

Honda Impeller Installation Guide